Turbopan

MiniTurbopan Gold Pan

SKU
8930615-config
As low as $16.99
Available For Delivery
Available For Click & Collect

The TurboPan design is a game changer in the gold panning industry making it now more likely and easier to identify and sive gold while panning. The spiral design feeds the gold into the center of the pan while discharging all dirt and rocks to the outer edges of the pan.

  • Waste Ejected Over Entire Rim
  • Spiral Riffles To Break Up The Dirt
  • Alternate Wash and Spin Cycles
  • Flat Riffles To Clean Up Concentrate
  • Sluice In a Pan
  • Detailed instructions:
  • 1. Place dirt into pan. It is best to only ¾ fill it, which is about 6kg. Ensure the concentric riffles are on the side away from you. These are the clean up riffles.
  • 2. Submerge pan underwater completely, holding the pan on each side. Rotate pan clockwise and anti-clockwise very quickly for about 5 seconds. This is to get the water to go right through the dirt and start the saturation process.
  • 3. Hold the pan with one hand. With your other hand, stir the dirt in the central collection trap, checking for compaction and clay where the water has not fully penetrated. Stir the dirt by hand until you're satisfied complete saturation has occurred.
  • 4. Move the pan in an anti-clockwise motion so that the load moves inside the pan anti-clockwise. The purpose of this is to get the dirt moving over the spiral riffles so that the gold will work its way into the grooves. It is important to go anti-clockwise so that the clays in suspension will not compact against the steep sides of the spiral riffles. An initial sharp movement helps to get the dirt moving. Swirl in an anti-clockwise direction for 25-30 seconds.
  • 5. Alternate between a centring swirl to get the "heavies" into the middle and the "lights" to the surface and outside, then an ejection swirl. It is normal for a little dirt to fl y out of the pan at the edge. If a lot is going out, slow down your swirling rhythm so that only a small amount flies out with each swirl. Keep swirling until the amount of material left just covers the central trap. There are several techniques for using this pan – and scraping out the waste by hand is one of them – but this is not recommended for beginners.
  • 6. Shake the pan vigorously forwards and backwards and from side to side for 10 seconds, to get the gold down off the clean-up riffles, so all the gold is in the central trap.
  • 7. While shaking the pan from side to side, tilt the pan forward and allow dirt to run out of the front of the pan. Ensure clean-up riffles are at the front of the pan – away from you.
  • 8. After half the dirt has been ejected, centre the pan again, do a few more clockwise swirls and repeat steps 6 & 7.
  • 9. Work out your own careful clean up technique for reducing concentrate to gold only or mostly gold only.
  • 10. Pick out nuggets. Pick up large flecks of gold by firstly drying your hand, wetting the end of your finger with saliva, and picking them up with the end of your finger. Place them into a jar, vial, etc.
  • 11. It's best to suck up gold fines and dust with a plastic squirter bottle that has a tube from the mouth of the bottle to the bottom of the bottle.
Write Your Own Review
You're reviewing: MiniTurbopan Gold Pan
You might also be interested in
© 2024 AUSSIE DISPOSALS. ALL RIGHTS RESERVED
TERMS & CONDITIONS